Hellcat heeft een update klaar van zijn Recovery Flasher. Deze update brengt ons bij versie 1.60 en heeft enkele handige wijzigingen. Het werkt nu op de HEN firmware en je kan nu terug keren tijdens het backuppen en herstellen van files. Maar er is nog meer. Voor een volledige changelog verwijzen we je graag door naar 'Lees verder'.

De applicatie werkt nu ook met de PSP 3000. Als het programma merkt dat het een Ta-88 V3 motherboard is, krijg je daarvan bericht.

Bron: Dl.Qj.net
Download: Recovery Flasher V1.60

Changelog:

* Updated 5.00-M33 installation to revision 6
* Changed autonaming of new backup folders to include date, firmware, psp model
* Made the resurrecion.prx replacement function working on all DDCs from 6 and above
* Added detection of PSP 3000 and PSP 2000 TA-088v3+. Flash writing
functions will be disabled on those PSPs as they are not CFW capable
and flashing would result in a brick
* Added support for "Firmware
Packs" - theese, like addons, packs will eliminate the need for a
complete new release only when a new (C)FW is released. Instead of
releasing a new Recovery Flasher it'll just be such a pack, enabling
Recovery Flasher to install the new firmware until an update of the
main app is done that supports the firmware natively. Can/Will also be
used for making Recovery Flasher install CFWs not supported, like GEN
and such.
* Added complete checksum-check of the updater .PBP going to be used to avoid corrupted/incomplete .PBPs causing a brick
* Added full verify of the NAND dump that got written to be sure you have a good one
* Added detection of HEN mode
* Added detection and propper handling if a backup set contains OFW instead of CFW (like when made from HEN)
* Added better NAND dump handling. New dumps are now created with names
similar to the (new) backup slot names (and now go into
/flash-nanddumps), incl. an ID for the PSP they are made on, on NAND
restore a list is shown with all available dumps matching the ID of the
current PSP to choose from (the ID matching should prevent choosing a
wrong dump accidentally)
* Added back/cancel on backup creation and restore
* Backups made from HEN mode are tagged to identify them as containing ORIGINAL firmware (as those backups do!)